Promag CON-485 Series Betriebsanleitung PDF herunterladen (Seite 7)

Memo-Graph S 1 Safety instructions

Endress+Hauser 7

1 Safety instructions

1.1 Notes on safety conventions and icons

The devices are safely built and tested according to state-of-the-art technology and have left the fac-

tory in perfect condition as regards technical safety. The devices comply with the relevant standards

and guidelines as per EN 61010 “Safety requirements for electrical equipment for measurement,

control and laboratory use”. They can, however, cause danger if used improperly or other than

intended.

Always refer to the safety instructions in these Operating Instructions labelled with the following

symbols:

Warning!

“Warning” draws attention to activities or procedures that can lead to injuries to persons or to safety

risks if not carried out properly. Observe the work instructions closely and proceed with care.

Caution!

“Caution” draws attention to activities or procedures that can lead to defective operation or to des-

truction of the device if not carried out properly. Follow the instructions carefully.

Note!

“Note” draws attention to activities or procedures that have an indirect effect on operation, or can

trigger an unforeseen device reaction if not carried out properly.

1.2 Designated use

This device is suitable for installation in control panels and cabinets in non-hazardous areas. It meets

the requirements of EN 61010-1 / VDE 0411 Part 1 and has left the factory in perfect condition as

regards technical safety.

The manufacturer does not accept liability for damage caused by improper or non-designated use.

The device can cause danger if used improperly or other than intended. If it is obvious that safe ope-

ration is no longer possible (e.g. visible damage), please place the device immediately out of service.

Secure the device against unintentional start-up.

1.3 Installation, commissioning and operation

Observe the following points:

• Installation, electrical installation, commissioning and maintenance of the device must only be

carried out by trained experts who have be authorised to do so by the system operator. These

experts must have read and understood these Operating Instructions and follow their instructions.

• The device must only be operated by personnel who have been authorised and instructed by the

system operator. These Operating Instructions absolutely must be followed.

• Before connecting the device, ensure that the power supply corresponds to the value specified on

the nameplate. The installer is responsible for ensuring that the measuring system is correctly con-

nected in accordance with the electrical wiring diagrams. Before switching on the system, again

check that all connections are correct.

• Primarily observe local regulations regarding opening and repairing electrical devices.

1 2 3 4 5 6 7 8 9 10 11 12 ... 97 98

Keine Kommentare

Promag CON-485 Series Betriebsanleitung Seite 7