Promag CON-485 Series Betriebsanleitung PDF herunterladen (Seite 12)

3 Installation Memo-Graph S

12 Endress+Hauser

3.3 Installation instructions

3.3.1 Mounting kit

To install the control panel, all you need is a screwdriver.

3.3.2 Panel mounting

Figure 2: Panel mounting for version with die-cast or stainless steel front

Make a panel cutout, 138+1 x 138+1 mm in size (acc. DIN 43700). Please observe the asymmet-

rical alignment of the front bezel to the casing.

The installation depth of the device is approx. 211 mm without, or 232 mm with, rear panel or ter-

minal cover.

1. Attach the control panel seal to the device and push it from the front through the panel cutout.

To avoid heat accumulation, we recommend keeping a distance of > 15 mm from the walls

and other devices.

2. Hold the device level and the hang jack screws in the openings (top/bottom or left/right for

IP54 ingress protection, all four for IP65 ingress protection).

3. Evenly tighten the screws on the jack screws using a screwdriver so that a secure, gap free seal

is guaranteed with the panel (recomended tension on the screws for an IP65 protection is 0.8

to 1.3 Nm).

Note!

Another support is only required for very thin control panel versions.

3.4 Post-installation check

After installing the control panel, please check the following points:

• Is the control panel seal mounted?

• Is the device fixed firmly in the control panel?

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 97 98

Keine Kommentare

Promag CON-485 Series Betriebsanleitung Seite 12