Promag CON-485 Series Betriebsanleitung PDF herunterladen (Seite 58)

5 Operation / adjusting device settings - Set-up to commissioning Memo-Graph S

58 Endress+Hauser

Note!

You can obtain the system parameters from your relevant network administrator.

The following system parameters must be set:

1. IP address

2. Subnet mask

3. Gateway

5.10.1 Menu: SETUP – Miscellaneous

All parameters that affect the device's operating system are configured in the setup - miscellaneous

menu.

The system parameters are input in the „RS232 / Ethernet“ menu.

Note!

This menu only appears if the device is equipped with an internal Ethernet interface.

5.10.2 MAC address

This displays the Ethernet address of the device. This number is set and registered at the factory. It

cannot be changed.

5.10.3 IP address allocation

The device is delivered with a preset IP address which must, however, be changed in the setup pro-

cedure. Before you can make the input in the device, an IP address valid for your network must be

defined.

Note!

The IP address must be unique within the network.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 97 98

Keine Kommentare

Promag CON-485 Series Betriebsanleitung Seite 58